GESTETNER DSM 730 DRIVER

Press the Reset Yellow key 3. Attach the front frame pawls and front and rear [A]. Then push down to lock the tabs on the front and rear end of the PCU. Assemble the PCU and install it in the machine. See Note in Bold Green above. Remove the front screw [A] x1 5.

Uploader: Mazuktilar
Date Added: 23 June 2018
File Size: 25.4 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 18549
Price: Free* [*Free Regsitration Required]

Release the front tab [C]. While continuing to turn the black gear, slowly move the pack left and right and pour the remaining half of the developer over the gestetnner until the developer is level. Separate the top [E] and bottom [F] of the development unit. Press and Hold the C key. Remove the top part [C] x1.

Release the rear tab [D]. Therefore, I would recommend cleaning off a desk or work area ahead of time, organize your partsthen remove the PCU unit and take it over to the area where you will be working. Install the PCU in the machine.

  CRAFTSMAN NEXTEC IMPACT DRIVER

Replace the drum [E] White clip x1 [F]. Attach the front frame pawls and front and rear [A].

Tighten the top screw [F]. Lightly tap the top of the PCU [A] with a screwdriver at 8 locations. If the holes are not aligned correctly, make sure that the tabs at the front, rear, and left side of the PCU are engaged correctly.

Turn the development roller gear [I] to remove toner from around the development roller. Remove some toner from the edge of the old blade with your finger, and apply it evenly along the full length of the new blade.

DSm725/730

Tighten the lower screw [E]. Separate the top and bottom parts of the PCU. Replace the cleaning blade [A] x2 Reinstallation: After the machine turns the development roller for 10 seconds, go to the next step. Remove the rear cover [B] x3, Coupling x1. Set the bottom on the vinyl sheet.

If you replaced PCU components: Continue to rotate the black gear until the developer is level. Do not spill developer on the gears or sponges. Remove the front stud [A]. Tighten the three screws and coupling [D]. Make 5 sample copies. The total rotation time is 30 seconds.

  LENOVO3000 Y500 DRIVER

Gestetner DSm EP Laser Printer Toner Cartridges

Replace the cleaning roller [F]. Therefore, I recommend installing the new drum unit in the machine right before you put the two halves back together.

Tap 2 or 3 times at each location, to make the toner fall into the development section. Remove the PCU from the machine. Turn on the main power switch.

Gestetner DSm730 Consumables

Follow the cautions below when handling a PCU. Assemble the development unit. Spread the vinyl sheet provided with the developer kit on a flat surface.

Author: admin